Materials:

• 4 50-70 pound lift magnets
• 8 2-inch copper wires
• soldering iron & solder
• really hot glue gun (if no glue, use duct tape)
• 2 nine volt batteries
• 2 switches
• shoes

Method:

1. Solder one of the wires to the positive point on the rocker switch and the positive point on the battery.
2. do the same for both negative points.
3. Now, on the shoe, glue one of the magnets onto the heel. (Make sure that it is really glued on)*
4. Do the same for the tip of the sole, close to the toes.
5. Glue the nine volt battery to the outer side of the shoe. Again make sure it’s really glued on.
6. glue the switch on the shoe too
7. then take the third wire and use the soldering iron to solder the wire to the positive side of the switch and the magnet at the heel of the shoe (this is where most of the power will be generated)
8. do the same except on the negative point and on the magnet at the tip of the shoe.
9. Reapeat with the other shoe
10. now that you’ve got your pair of hover shoes, take into consideration that you wont be able to fly all pro-like as soon as you put the shoes on.
11. Go into a place where there is like metal beaming underground, for instance, a garage. Find the beam and stand over it . Turn the shoes on, wait about 5- 15 minutes and then you will slowly raise off the ground. MAKE SURE YOU HAVE SOMETHING TO HOLD ONTO IF IT IS YOUR FIRST TIME.

ENJOY!